JTAG reflash

Ok, so I pulled off all the plastic from my Augen e-Go. The last screw was hidden under the WindowsCE license sticker. There is a little trick to getting the keyboard off, but just pull and it shouldn't break (mine's fine).

Ok, so Augen removed the boot firmware/upgrade selection (F1 normally). I want to reflash this netbook using JTAG. Once I do this, I will try to port linux natively. Provided my homework doesn't pile up too much.

Does anyone have info on this? For example which pins on the board are JTAG?

Pins for JTAG: [You must be registered and logged in to see this link.]
solder:[You must be registered and logged in to see this link.]

This pins are not connected to any IC (CN1 is fake on my PB).
Processor AK8802 pins are 41-44:
36-TRST
41-TMS
42-TDI
43-TDO
44-RTCK
45-TCLK

Do you have specification for ak88?

It is not vary from AK7802 [You must be registered and logged in to see this link.]
Difference in some multimedia instructions & hardware codecs for audio/video.